Search
Browse Categories
Use for heating fluid heat transfer media, tar, petroleum oils, asphalt, wax, paraffin, degreasing solvents, alcohol, molten salt, and other solutions not corrosive to steel sheath. Sheath temperatures to 750°F (399°C) dependant on application.
Use for heating weak solutions, process water, oils, tar, caustic soda, detergent, alkaline solutions, molten salts, deionized or pure water & other aqueous solutions & gasses not corrosive to Incoloy® sheath. Sheath temperatures to 1600°F (871°C)
Use for heating clean water, process water, water with very weak chemical solutions, demineralized, deionized or hot water storage and other aqueous solutions not corrosive to copper sheath. Sheath temperatures to 350°F (177°C).

Immersion Heaters

Start by selecting the immersion heater sheath material above

 

Immersion Heater Additional Information:

 
This is a partial list of our available stock and standard immersion heaters. Sheath materials of Incoloy, Steel, Copper, & various grades of Stainless Steel are available to meet your application requirements.  Screw Plug, Flanged, Over the Side, Circulation, Custom Designs and other configurations are available in both stock and standard designs.

List of Stock & Standard Screw Plug Immersion Heaters

List of Stock & Standard Flanged Immersion Heaters

ISE Heat-up Wattage Calculator

Contact ISE for application assistance or products not found here.

Shopping Cart
Your cart is empty.
 
 
 
 
ISE, Inc.
10100 Royalton Rd.
Cleveland, OH 44133
 
Tel:  (440) 237-3200
Fax: (440) 237-1744
 
 
 
Toledo Area Office:
 
Maumee, OH 43537

Tel:  (419) 893-3330
Fax: (419) 893-2151