In Stock For Same Day Shipment We will advise immediately  if your order will be delayed
UNIVERSAL PRESSURE INDICATOR The ISE/Gentan model GT434 Digital indicator/power supply is designed for use with any four leg, 350 ohm Wheatstone bridge pressure transducer. Zero and span can be easily adjusted without removing the module. Shunt calibration is a standard feature.
EASY TO READ LED DISPLAY The large 4½ digit, 1/3 inch LED display is easy to read, even from a distance. Custom face plates are not required for specific scales because every unit can be set for 12 different ranges.  Other markings can be easily added for engineering units. The last digit is a fixed zero.
OPTIONAL DUAL ALARM SETPOINTS Two alarms can be selected for above or below setpoint control. Relays provide N.O. (normally open) and N.C. (normally closed) contacts for maximum flexibility. Adjustments are made through pots on the faceplate.
VERSATILE Provides a choice of recorder outputs, damping constant, transducer sensitivities, input power, shunt-resistor calibrations, peak-hold, and reset options.
INDUSTRY COMPATIBLE Can be set to operate with Gentran or other styles of transducers.
EASY INSTALLATION The easy-to-mount aluminum housing fits a 1/4 DIN cutout. Slide-type metal brackets hold the case firmly in place and can be installed quickly. The electronic module can be easily removed for option selection or service
Standard Pressure Ranges:
0-1,500 psig 0-3,000 psig 0-5,000 psig 0-10,000 psig 0-15,000 psig
Accuracy:
Display: ±0.1% of full scale Recorder Output:  ±0.1% of full scale Repeatability: ±0.1% of full scale Linearity: ±0.1% of full scale Stability: ±0.1% of full scale
Physical Characteristics:
Size: 1/4 DIN Display: 4½ digit LED, 1/3 inch height, last digit fixed zero and selectable decimal point Operating Temperature: 0-140°F Weight: 2.5 lbs.
Power:
106-125 or 200-250 VAC, 50/60 hz, 1/8 Amp maximum
Calibration:
Zero Adjustment: ±35% with front panel pot Sensitivity Adjustment (Span): 1-2.5 mV/V or 2.5-5.0 mV/V, Switch selectable and fully adjustable. Shunt Resistance Calibration: Selectable for Gentran or Dynisco Response Time (Damping): Selectable at 0.3 or 5.0 seconds
Recorder Output:
Standard: Selectable 0-1 VDC, 0-2 VDC, 0-5 VDC & 0-10 VDC Optional: 4-20 mA, Load from 15-600 ohms
Transducer Power Supply:
:8.2 VDC ±5.0%
Optional Alarm Outputs:
Dual Relays: 2 SPDT (Single Pole Double Throw) Relay Rating: 8 Amp @ 125/250 VAC, 5 Amp @ 30 VDC Set Point Range: 1-100% of full scale Accuracy: ±0.3% of full scale Hysteresis: ±0.5% of full scale Indication: Front panel LED's Mode: Above or below set point Reset: Automatic or manual

.